TechniSat CAM 1 plus - Manual (Page 34)

Or
>
Press the Menu key to resume normal operation.
All settings selected will be automatically stored
Once you have customized the Electronic Programme Guide to your personal preferences,
the process of data acquisition by the EPG can be started manually as follows
>
Use the On/Standby key to switch the receiver off (standby).
> Press the key
EPG
within 5 seconds.
The receiver will now carry out the data acquisition procedure. This is shown in the
display by the letters
EPLd .
> The data acquisition process can be interrupted by switching on (
On/Standby
key)
the receiver.
7.6 Unblocking the parental lock for individual channels
Enter your PIN in order to get to the appropriate menu, then proceed as described in Point
7.3, removing individual red crosses by pressing the
OK key. In this manner, individual chan-
nels can again be excluded from the parental lock control.
7.7 Programme Search
As mentioned previously, your receiver has been pre-programmed to receive signals from
the ASTRA and EUTELSAT satellites. In order to add new channels, or those received from
other satellites, there are four possibilities of carrying out a programme/channel search.
Please note that your Basic Settings (5.2 -
search mode ) will determine whether only free-
to-air or all (free-to-air and scrambled) channels will be searched.
1. All:
All satellites and transponders selected will be searched.
2. Satellite:
Choose this option to find specific channels or bouquets.
3. Transponder:
Choose this option to scan a specific transponder of a specific satellite. You can search for
all or selected programmes of a particular transponder.
4. Program:
This option is intended specifically for cases where the desired channel could not be found
by any of the other options. Please note that to utilise this search method, you will have to
enter the specific Service ID Number of the channel, which you can obtain from the broadca-
ster, or from the Internet.
Once the search has been completed, the number of channels identified by your receiver will
be displayed on your screen, also stating how many of these are new channels. New chan-
nels are shown in red type in the Total List, and can be transferred to the User List in accor-
dance with
Point 7 (Changing the Basic Programming).
> In order to search for programmes, press the Menu key to display the Main Menu .
34
bed_anl_TechniBox CAM1plus_engl.qxd 30.03.01 14:50 Seite 34