TechniSat CAM 1 plus User Manual
Page 36
>
Press
OK
again to start the search.
>
The search can be terminated at any time by pressing
OK.
It is quite likely that a full scan may take 15 minutes or longer.
Please note any notes and information displayed on the screen.
7.7.3 Transponder
This search mode can be used to search a specific transponder (see Point 9: Technical
Terms) for channels. In order to use this function, you will have to enter data relating to the
transponder.
>
Use the
up/down arrow
keys to select the
Transponder
option.
>
Confirm with the
OK
key.
The menu
>Search>Transponder
will be displayed.
Satellite
In this line you must select the satellite corresponding to the selected transponder.
>
Use the
up/down
arrow keys to select the
Satellite
option.
>
Press
OK
to display a table listing four satellites.
>
Use the
up/down arrow
keys to mark the selected satellite.
>
Confirm with the
OK
key.
The selected satellite has now been acquired by the menu.
Transponder frequency
>
Use the
up/down arrow
keys to mark the entry
Transponder frequency
.
>
Use the
numeric key pad
to enter the correct frequency in this line.
Polarization
>
Use the
up/down arrow
keys to mark the entry
Polarization
.
>
Use the
OK
key to enter the polarisation plane (
h
orizontal or
v
ertical) on which the
desired programme is broadcast.
Symbol rate
The symbol rate indicates the volume of data transmitted per second. An example might be
27500, indicating transmission of 27500 symbols per second.
>
Use the
up/down arrow
keys to mark the entry
Symbol rate
.
>
Use the
numeric key pad
to enter the correct symbol rate.
>
Once you have entered all the information, start the search by using the
up/down
arrow
keys to mark the entry
Start search
.
>
Confirm with the
OK
key.
Please note any notes and information displayed on the screen.
7.7.4 Channel/Programme
If a channel cannot be found by means of any of the first three search modes, it may be
necessary to enter a programme-specific Service-ID-Number. This number will be obtainable
directly from the service provider/broadcaster, or from the Internet.
Select the menu
>Search>Program
.
36
bed_anl_TechniBox CAM1plus_engl.qxd 30.03.01 14:50 Seite 36