Wolf Appliance Company DUAL FUEL RANGES - Manual (Page 11)

11
C O N T R O L K N O B S
The control knobs are posi-
tioned to correspond to the
burners they regulate. The
knobs on the far left regulate
the burners on the left side.
Conversely, the knobs on the
far right regulate the burners
on the right side.
The precision fit of the control
knobs requires the use of a
nyliner insertion between the
knob and bezel. When remov-
ing knobs for cleaning, place
the bearing back inside the
bezel for easy installation of the
knobs after cleaning.
F L A M E H E I G H T
A N D A P P E A R A N C E
Select a flame that is just high
enough to maintain the desired
cooking speed and sized to fit
the base diameter of the pan.
Never extend the flame beyond
the base of the pan. Smaller
diameter pans should be used
on the left rear burner.
The flame on natural gas
should be blue with a deeper
blue core. There should be
minimal trace of a yellow flame.
A yellow flame indicates an
improper mixture of air/gas or
impurities in the gas supply to
the range. If this consistently
occurs, call a Wolf Factory
Authorized Service Center
Technician to adjust the
mixture. With LP gas, some
yellow tipping to the flame is
acceptable and may not require
an adjustment.
A "popping" sound may be
noticed with LP gas when the
surface burner is turned off.
This is normal.
W
O L F
T
O P
S
U R F A C E
O
P E R A T I O N
To light a burner, push in and
turn the corresponding control
knob counter clockwise to
HIGH setting. You will hear a
"clicking" and see the burner
ignite. Once the burner is lit,
continue turning the knob
counter clockwise to any one of
the settings – HIGH through
LOW.
To select a SIMMER setting,
turn the burner knob to the
LOW setting; you will feel a
stop-detent in the knob rota-
tion. Push in on the knob,
continuing to turn it counter
clockwise. This moves the
flame to the second tier. Now,
select any variation within the
SIMMER flame settings –
HIGH through LOW.
Each knob is designed to be a
"push-to-turn knob". Although
this is a child-safe design,
children should never be left
unattended in the kitchen when
the range is in use.
G R AT E P L A C E M E N T
The low profile, cast iron
grates are designed for a close
fit. This enables you to move
pans easily from one burner to
another without having to lift
the pan or have it tip over
between the grates. Each grate
sets securely on dimples on
each corner of the burner pan.
Continuous grates are inter-
changeable (excluding the
charbroiler grate with burner
grate).
Position the porcelain coated,
cast iron grates over two
burners. Rubber pads located
under the grate support legs
will match up with the dimples
on the burner pans.
The drip pan holds as much as
2-1/2 cups of a liquid spillover
per two-burner pan.
Nyliner insertion
NYLINER INSERTION