Yamaha AW2400 - Manual (Page 120)

AW2400 Owner’s Manual
Inserting an Effect Into a Channel
Eff
ects
120
14
5
Use the [DATA/JOG] dial or [INC]/[DEC]
keys to select the desired effect and/or I/O
card channel, then press the [ENTER] key.
When EFF1–4 is selected the corresponding effect
will be inserted in the signal path.
The signal flow is as follows.
When SLOT1–16 is selected an external effect processor
can be inserted into the channel via the selected I/O card
channel. In this case the signal flow is as follows.
6
To select the insert point move the cursor
to the symbol below INSERT EFF on the
display and press the [ENTER] key.
Press [ENTER] repeatedly to sequentially select the
pre-EQ
→ post-EQ pre-fader → post-fader insert
points.
When an effect and compressor are both inserted at the
same point you can move the cursor directly to the
insert point and press the [ENTER] key to swap the
positions of the effect and compressor.
7
Call the EFFECT screen FX Edit page or FX
Lib. page to adjust the internal effect mix
balance (the balance between the effect and
direct signals).
8
Use the MIX BALANCE field knob to bal-
ance the effect and direct sound as
required.
A setting of 0% produces only the direct sound while a
setting of 100% produces only the effect sound.
Insert points
ON
PHASE GATE
LVL
● INSERT EFF = EFF 1
EQ
ATT
Effect 1
■ External effect inserted pre-EQ
(input channel)
ON
PHASE GATE
LVL
● INSERT EFF = SLOT1
EQ
ATT
Output channel = 1 Input channel = 1
I/O card
External effect
processor
■ Internal effect inserted pre-EQ
(input channel)
• Refer to “Editing Effects” on page 121 for details on the
EFFECT screen FX Edit page.
HINT