Yamaha AW2400 - Manual (Page 187)

Command Editing Automix data In a Specified Region
187
AW2400 Owner’s Manual
A
utomix
19
1 PARAMETERS field
The following parameters can be selected for editing.
• FADER, CH ON, PAN, EQ buttons
...........Faders, Channel [ON] keys, pan, and
EQ operations.
• LIBRARY (CH, GATE, COMP, EQ) buttons
...........Channel library (CH), gate library
(GATE), compressor library (COMP),
and EQ library (EQ) recall.
• SCENE button .................Scene recall.
• EFF LIB 1–4 buttons .......Effect 1–4 library recall.
• AUX/ON 1–4 buttons .......AUX 1–4 send level and
on/off switching.
• EFF/ON 1–4 buttons........Effect 1–4 send level
and on/off switching.
B COMMAND
Displays the currently selected edit command.
C Channel/Region
The channel and region to which the edit command
will apply are specified here. The display will change
according to the command selected in
B .
D EXECUTE button
The selected edit command is executed when the cur-
sor is moved to this button and the [ENTER] key is
pressed.
2
Move the cursor to the button in the
PARAMETERS field corresponding to the
parameter to be edited, and press the
[ENTER] key.
Multiple parameters can be selected.
3
Move the cursor to the COMMAND field and
use the [DATA/JOG] dial or the [INC]/[DEC]
keys to select a command, then press the
[ENTER] key.
The following commands can be selected.
• ERASE........ Erase all occurrences of the specified
parameter(s) in the specified region.
• COPY.......... Copy all occurrences of the specified
parameter(s) in the specified region to
the specified position in the specified
destination channel.
• MOVE.......... Move all occurrences of the specified
parameter(s) in the specified region to
the specified position in the specified
destination channel. The original
parameters will be erased.
The display will change according to the selected edit
command as follows.
● When the ERASE command is selected:
1 The target channel can be selected from
the following.
• IN 1–16 ....... Input channels 1–16
• TR 1–24 ...... Track channels 1–24
• RTN 1–4...... Effect return channels 1–4
• BUS 1, 2 ..... Bus master channels 1, 2
• AUX 1–4...... AUX send master channels 1–4
• EFF 1–4 ...... Effect send master channels 1–4
• ST ............... Stereo output channel
• ALL ............. All channels
B The start point of the region to be edited is
specified in counter format.
C The end point of the region to be edited is
specified in counter format.
● When the COPY or MOVE command is
selected:
1 Specifies the source channel for the copy
or move operation.
The channels that can be selected are the same as
for ERASE, above.
B The start point of the source region for the
copy or move operation specified in
counter format.
C The end point of the source region for the
copy or move operation is specified in
counter format.
D Specifies the destination channel for the
copy or move operation.
Depending on the source channel for copy or
move operation, the channels that can be selected
vary.
E The start point of the destination region
for the copy or move operation specified
in counter format.
• The channel selection will be ignored when editing library,
scene or effect settings.
HINT
A
B
C
D E
B A
C