Yamaha AW2400 - Manual (Page 174)

AW2400 Owner’s Manual
Editing various settings for the song
Song management
174
18
Here’s how to edit various settings for a song, such as selecting the counter display format and
time code format.
1
Call the Setting page by either pressing the
Work Navigate section [SONG] key as many
times as necessary, or by pressing the [F2]
key after pressing the [SONG] key.
The SONG screen Setting page will appear.
2
To change the counter display format move
the cursor to the ABS, RELATIVE, SECOND,
or TIME CODE button and press the
[ENTER] key.
In the Setting page, use the following buttons to select
the display format for the counter that is shown in the
center of the top line in the display.
• ABS (absolute time)
................ Displays the current location in
hours/minutes/seconds/millisec-
onds, with the absolute time zero
location as 0.
• RELATIVE (relative time)
................ Displays the current location in
hours/minutes/seconds/millisec-
onds, with the relative time zero
location as 0.
• SECOND........... Displays the current location in
hours/minutes/seconds/millisec-
onds, with the Start point as 0.
• TIME CODE ...... Displays the current location in
time code (hours/minutes/sec-
onds/frames), with the Start point
as 0.
3
To change the time code frame rate move
the cursor to the 24, 25, 30, or 30D button
and press the [ENTER] key.
You can choose one of the following frame rates to
specify the minimum unit of time code.
• 24 ..........24 frames/second
• 25 ..........25 frames/second
• 30 ..........30 frames/second (30 non-drop frame)
• 30D........29.97 frames/second (30 drop-frame)
Editing various settings for the song
• These settings apply only to the current song. Before you perform this procedure, load the song to be
edited.
• The counter display setting will be saved with the song data when the song is saved.
NOTE
• The counter in the upper right of the display always shows the
current location in measure/beat units, relative to the Start
point.
• The measure/beat display will depend on the settings in the
Tempo page of the EDIT screen. For details, refer to “Creating
a tempo map” (
→ p. 175).
NOTE
• This setting affects both the counter time code display and the
MTC that the AW2400 transmits and receives. If the AW2400
is sending or receiving MTC to or from an external device, you
must set both devices to the same frame rate.
HINT
• The frame rate cannot be changed while the AW2400 is run-
ning.
NOTE