Yamaha AW2400 - Manual (Page 227)

227
AW2400 Owner’s Manual
Digital Input/Output & Optional Card Settings
23
4
Move the cursor to the STEREO BUS CAS-
CADE field.
Cascade connection settings are made in the STEREO
BUS CASCADE field.
1 STEREO BUS CASCADE button
Enables or disables the cascade connection.
B ATT knob
Adjusts the level of the signal received at the [DIGI-
TAL STEREO IN] connector.
5
Move the cursor to the STEREO BUS CAS-
CADE button and press the [ENTER] key.
This connects the digital audio signal received from
the external device directly to the AW2400 stereo bus.
6
Use the ATT knob to adjust the level of the
received digital signal as required.
You can now mix and record the signals from the
AW2400’s own inputs along with the digital audio
received at the [DIGITAL STEREO IN] connector to
the AW2400 stereo track.
You can visually check the status of the signals received at the [DIGITAL STEREO IN] connector
as well as signals received via an I/O card installed in the rear-panel slot in the DIO screen Sta-
tus page.
To call this page press the Work Navigate section [DIO]
key as many times as necessary, or press the [F2] key after
pressing the [DIO] key. This is a display-only page that
does not include any editable settings. This page contains the following items.
1 Status
Indicates the status of received digital signals. The mean-
ings of the displays are as follows:
• Fs (Sampling Frequency)
Indicates the sampling frequency of the received digital
signal.
• EMPHASIS
Indicates whether emphasis is on or off for the received
digital signal.
B A
• In order to record the signal received at the [DIGITAL STE-
REO IN] connector the UTILITY screen Preference page CD/
DAT DIGITAL REC button must be set to ENABLE.
NOTE
Check the Status Of the Digital Input Signal
B D C A
Parameter values Description
44.1k Sampling frequency = 44.1kHz
48k Sampling frequency = 48kHz
None Unknown sampling frequency
UNLOCK
No input signal, or inappropriate input
signal.
Parameter values Description
On Emphasis ON
Off Emphasis OFF
??? Unknown
• The following status displays will appear as “----” when a MY8-AT,
MY8-TD, MY16-AT, or MY16-TD I/O card is installed.
NOTE
Wordclock and Cascade Settings • Check the Status Of the Digital Input Signal