Figure 146 wall-mounting example – ZyXEL Communications V300 User Manual
Page 158
Appendix A Product Specifications
V300 User’s Guide
158
Wall-mounting Instructions
Complete the following steps to hang your V300 on a wall.
"
See
for the size of screws to use and how far apart to
place them.
1 Select a position free of obstructions on a sturdy wall.
2 Drill two holes for the screws.
1
Be careful to avoid damaging pipes or cables located inside the wall when
drilling holes for the screws.
3 Do not insert the screws all the way into the wall. Leave a small gap of about 0.5 cm
between the heads of the screws and the wall.
4 Make sure the screws are snugly fastened to the wall. They need to hold the weight of
the V300 with the connection cables.
5 Align the holes on the back of the V300 with the screws on the wall. Hang the V300 on
the screws.
Figure 146 Wall-mounting Example
The following are dimensions of an M4 tap screw and masonry plug used for wall mounting.
All measurements are in millimeters (mm).