ZyXEL Communications V300 - Manual (Page 57)

Chapter 5 LCD Menus: Basic Settings
V300 User’s Guide
57
5.4.2.3 Timeout Setting
Use this menu to set the length of time the V300 waits before redirecting an incoming call
when no answer forwarding (NoAS FW) is enabled (either in the Call FW > Cond FW menu
or in a specific call forwarding (Specific FW) entry.
Select Call FW > Timeout Set. The following screen displays.
Figure 33 LCD Menu: Timeout Setting
To edit the length of time the V300 waits before forwarding a call, press MENU and then enter
the new call forward timeout period in (from 1 to 99 seconds). Press MENU again to save the
new forward timeout period.
5.4.2.4 Specific Forward
These menus allow you to set the V300 to recognize incoming calls from a certain number and
then redirect the calls to another number. You can configure multiple specific call forwarding
rules. Each incoming call number can be set to redirect to a different call forwarding number.
Select Specific FW in the Call FW menu. The following screen displays.
Figure 34 LCD Menu: Specific Forward
The following table describes the labels in this screen.
5.4.2.4.1 Specific Forward Entry Table
When you select Entry Table in the Specific FW menu, the following screen displays. You
can configure up to ten specific forwarding entries.
Figure 35 LCD Menu: Specific Forward Entry Table
The following table describes the labels in this screen.
5 Timeout: (sec.)
15
6 Specific FW:
1 Active
Table 16 LCD Menu: Specific Forward
LABEL DESCRIPTION
Active Select this to turn specific call forwarding on or off. This setting applies to
all specific call forward entries.
Entry Table Select this to see and edit the list of specific call forwarding rules.
2 Entry Table:
1 Entry1
Table 17 LCD Menu: Specific Forward Entry Table
LABEL DESCRIPTION
Entry 1 ~ 10 Select a specific call forwarding entry to see or edit the corresponding rule.