2 resetting the v300, 2 phone functions, 1 making a call – ZyXEL Communications V300 User Manual
Page 35
Chapter 2 Hardware
V300 User’s Guide
35
The LCD menus allow you to configure and control the V300. See
details on configuring the V300 via the LCD menus.
2.1.2 Resetting the V300
If you want to reset the V300 to its factory defaults (if you forgot the web configurator
password, for example) press and hold the RESET button for approximately ten seconds. The
V300 restarts automatically.
"
If you reset the V300, all settings return to their factory defaults. All data stored
in the V300 (phonebook entries, for example) will be lost.
2.2 Phone Functions
This section describes how to use your V300’s basic telephone functions. See
for information on the using the V300’s LCD screen menus and
for information on how to use the V300’s phonebook.
2.2.1 Making a Call
1 Start the call:
• If you want to use the handset:
Lift the handset.
• If you want to use the speakerphone:
Press the SPEAKER key.
• If you want to use a headset:
Press the HEADSET key.
2 Check that you can hear a dial tone.
3 Enter the number you want to call. If you have numbers stored in the V300’s phone
book, you can use the navigator to select from the list of entries.
4 Press the yellow SEND key.
During the call:
• If you are using the headset or the speakerphone, you can switch to the handset by
lifting it off the hook.
• If you are using the handset or the speakerphone, you can switch to the headset by
pressing the HEADSET key.
• If you are using the handset or a headset, you can switch to the V300’s speakerphone
by pressing the SPEAKER key.
Note that the call ends if you are using the speakerphone and press the SPEAKER key,
or if you are using the headset and press the HEADSET key.