Yamaha CVP-109 EN - Manual (Page 182)

182
CVP-109/107/105/700
If AUTO is selected as the harmony mode, the Clavinova will produce
harmony notes in either Vocoder or Chordal mode, based on the most
appropriate harmony part. The harmony part is selected automatically
according to the current performance method, as shown below:
If you select CHORDAL or VOCODER, the Clavinova will produce
harmony notes in the selected mode, based on the harmony part specified
by the
HARMONY PART function.
Harmony Part
(See below.)
R1
LEFT
ACMP
XF
As per Vocal
Harmony data
Performance Method
Playing keyboard in Single mode (page
31) or Dual mode (page 38)
Playing keyboard in Split mode (page 41)
Playing Auto Accompaniment (page 69)
Playing back Acmp Assist data (page 81) or
song with Auto Accompaniment data (page 133)
Playing back song with Vocal Harmony data
Harmony Mode
(See page 181.)
Vocoder
Chordal
Chordal
Chordal
As per Vocal
Harmony data
HARMONY PART
• Settings: R1, LEFT, ACMP, 1 — 16,
XF, OFF
• Basic setting: Automatically set by
AUTO harmony mode,
depending on perform-
ance method (see table
above).
Harmonies produced using the Chordal or Vocoder vocal harmony
modes (page 181) can be based on different musical parts played — or
played back — on the Clavinova. When
AUTO is selected as the har-
mony mode, the part used as the basis for the harmony is selected auto-
matically according to the current performance method (see table above).
You can instruct the Clavinova to base the harmony on a specific part by
changing the
HARMONY PART function on page 3 of the VOCAL
HARMONY display.
Press the HARMONY PART button to select the function, then use
the data dial or the [–] and [+] buttons to change the value.
➔ The selected value is displayed.
180
■ Changing the Harmony Part
...................................................................
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Singing with Vocal Harmony
(CVP-109/107/700)