Yamaha TG500 - Manual (Page 99)

87
PERFORMANCE EDIT MODE / 3: Full Edit. 3-1: Layer
3-2-11: CONTROL 1 / 3-2-12: CONTROL 2
Ef1Prm1
Ef1Prm2
Ef1Prm3
Ef1Prm4
Ef1Prm5
Ef1Prm6
Ef1Prm7
Ef1Prm8
Ef_Out1a
Ef_Out1b
Ef2Prm1 Ef2Prm2
Ef2Prm3
Ef2Prm4
Ef2Prm5
Ef2Prm6
Ef2Prm7
Ef2Prm8
Ef_Out2a
Ef_Out2b
Ef2_Mix
Out1_Wet Out2_Wet
Ctrl1Min
Ctrl1Max
LFO_Wave
LFO_Spd
LFO_Dly
Ef_Ins1b
Ef_Ins2a
Ef_Ins2b
Min (Minimum parameter value)
Range: 0 … 100
Sets the lower limit of the control range. A setting of “0”, for example,
means that when the lowest control change value is received the assigned
parameter will also be set to its lowest value. A setting of “50” means that the
lowest control change value will set the assigned parameter to about 50% of its
range (a parameter with a range of 0 to 127, for example, would be set to
about 63).
Max (Maximum parameter value)
Range: 0 … 100
Sets the upper limit of the control range. A setting of “100”, for example,
means that when the highest control change value is received the assigned
parameter will also be set to its highest value. A setting of “80” means that the
highest control change value will set the assigned parameter to about 80% of
its range (a parameter with a range of 0 to 127, for example, would be set to
about 102).