ZyXEL Communications ZyXEL ZyAIR NWA-3500 User Manual
Page 100
Chapter 6 Wireless Configuration
ZyXEL NWA-3500 User’s Guide
100
See
for information on the other labels in this screen.
Fragmentation
Threshold
The threshold (number of bytes) for the fragmentation boundary for directed
messages. It is the maximum data fragment size that can be sent. Enter an
even number between 256 and 2346.
Output Power
Set the output power of the ZyXEL Device in this field. If there is a high density
of APs in an area, decrease the output power of the ZyXEL Device to reduce
interference with other APs. Select from 100% (Full Power), 50%, 25%, 12.5%
and Minimum. See the product specifications for more information on your
ZyXEL Device’s output power.
Enable WDS Security Select this to turn on security for the ZyXEL Device’s Wireless Distribution
System (WDS). A Wireless Distribution System is a wireless connection
between two or more APs. If you do not select the check box, traffic between
APs is not encrypted.
Note: WDS security is independent of the security settings
between the ZyXEL Device and any wireless clients.
When you enable WDS security, also do the following:
•
Select the type of security you want to use (TKIP or AES) to secure traffic
on your WDS.
•
Enter a pre-shared key in the PSK field for each access point in your WDS.
Each access point can use a different pre-shared key.
•
Configure WDS security and the relevant PSK in each of your other access
point(s).
Note: Other APs must use the same encryption method to
enable WDS security.
TKIP (ZyAIR Series
Compatible)
Select this to enable Temporal Key Integrity Protocol (TKIP) security on your
WDS. This option is compatible with other ZyXEL access points that support
WDS security. Use this if the other access points on your network support
WDS security but do not have an AES option.
Note: Check your other AP’s documentation to make sure it
supports WDS security.
AES
Select this to enable Advanced Encryption System (AES) security on your
WDS. AES provides superior security to TKIP. Use AES if the other access
points on your network support it for the WDS.
Note: At the time of writing, this option is compatible with
other ZyXEL NWA-3500 access points only.
#
This is the index number of the bridge connection.
Active
Select the check box to enable the bridge connection. Otherwise, clear the
check box to disable it.
Remote Bridge MAC
Address
Type the MAC address of the peer device in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
PSK
Type a pre-shared key (PSK) from 8 to 63 case-sensitive ASCII characters
(including spaces and symbols). You must also set the peer device to use the
same pre-shared key. Each peer device can use a different pre-shared key.
Table 23 Wireless: Bridge/Repeater
LABEL
DESCRIPTIONS