Table 2 the status screen – ZyXEL Communications ZyXEL ZyAIR NWA-3500 User Manual
Page 48
Chapter 3 Status Screens
ZyXEL NWA-3500 User’s Guide
48
The following table describes the labels in this screen.
Table 2 The Status Screen
LABEL
DESCRIPTION
Automatic Refresh
Interval
Enter how often you want the ZyXEL Device to update this screen.
Refresh
Click this to update this screen immediately.
System Information
System Name
This field displays the ZyXEL Device system name. It is used for
identification. You can change this in the System > General screen’s
System Name field.
Model
This field displays the ZyXEL Device’s exact model name.
Firmware Version
This field displays the current version of the firmware inside the device. It
also shows the date the firmware version was created. You can change the
firmware version by uploading new firmware in Maintenance > F/W
Upload.
System Up Time
This field displays the elapsed time since the ZyXEL Device was turned on.
Current Date Time
This field displays the date and time configured on the ZyXEL Device. You
can change this in the System > Time Setting screen.
WLAN1 Operating
Mode
This field displays the current operating mode of the first wireless module
(AP, Bridge / Repeater, AP + Bridge or MBSSID). You can change the
operating mode in the Wireless > Wireless screen.
WLAN2 Operating
Mode
This field displays the current operating mode of the second wireless
module (AP, Bridge / Repeater, AP + Bridge or MBSSID). You can
change the operating mode in the Wireless > Wireless screen.
Management VLAN
This field displays the management VLAN ID if VLAN is active, or
Disabled if it is not active. You can enable or disable VLAN, or change the
management VLAN ID, in the VLAN > Wireless VLAN screen.
IP
This field displays the current IP address of the ZyXEL Device on the
network.
LAN MAC
This displays the MAC (Media Access Control) address of the ZyXEL
Device on the LAN. Every network device has a unique MAC address
which identifies it across the network. Your ZyXEL Device features dual
wireless module, and has two MAC addresses. The MAC address of the
first wireless module (WLAN1) is used on the LAN.
WLAN1 MAC
This displays the MAC address of the first wireless module.
WLAN2 MAC
This displays the MAC address of the second wireless module.
System Resources
Flash
This field displays the amount of the ZyXEL Device’s flash memory
currently in use. The flash memory is used to store firmware and SSID
profiles.
Memory
This field displays what percentage of the ZyXEL Device’s volatile memory
is currently in use. The higher the memory usage, the more likely the
ZyXEL Device is to slow down. Some memory is required just to start the
ZyXEL Device and to run the web configurator.
CPU
This field displays what percentage of the ZyXEL Device’s processing
ability is currently being used. The higher the CPU usage, the more likely
the ZyXEL Device is to slow down.
WLAN1 Associations This field displays the number of wireless clients currently associated to
the first wireless module. Each wireless module supports up to 128
concurrent associations.