ZyXEL Communications ZyXEL ZyAIR NWA-3500 - Manual (Page 45)

Chapter 2 Introducing the Web Configurator
ZyXEL NWA-3500 User’s Guide
45
2.2.1 Methods of Restoring Factory-Defaults
You can erase the current configuration and restore factory defaults in three ways:
Use the RESET button to upload the default configuration file. Hold this button in for about
10 seconds (the lights will begin to blink). Use this method for cases when the password or IP
address of the ZyXEL Device is not known.
Use the web configurator to restore defaults (refer to
Chapter 17 on page 205 ).
Transfer the configuration file to your ZyXEL Device using FTP. See the section on SMT
configuration for more information.
2.3 Navigating the Web Configurator
The following summarizes how to navigate the web configurator from the Status screen.
Click LOGOUT at any time to exit the web configurator.
Check the status bar at the bottom of the screen when you click Apply or OK to verify that the
configuration has been updated.
Figure 10 The Status Screen of the Web Configurator
Click the links on the left of the screen to configure advanced features such as SYSTEM
(General Setup, Password and Time Zone), WIRELESS (Wireless, SSID, Security, RADIUS,
Layer-2 Isolation, MAC Filter), IP, ROGUE AP (Configuration, Friendly AP, Rogue AP),
REMOTE MGNT (Telnet, FTP, WWW and SNMP), AUTH. SERVER (Setting, Trusted AP,
Trusted Users), CERTIFICATES (My Certificates, Trusted CAs), LOGS (View Logs and
Log Settings) and VLAN (Wireless VLAN and RADIUS VLAN).