ZyXEL Communications ZyXEL ZyAIR NWA-3500 - Manual (Page 185)

Chapter 15 Log Screens
ZyXEL NWA-3500 User’s Guide
185
15.4 Log Commands
Go to the command interpreter interface (the Command Interpreter appendix explains how to access and
use the commands).
15.4.1 Configuring What You Want the ZyXEL Device to Log
Use the sys logs load command to load the log setting buffer that allows you to configure which logs
the ZyXEL Device is to record.
Use sys logs category followed by a log category and a parameter to decide what to record
Use the sys logs save command to store the settings in the ZyXEL Device (you must do this in order
to record logs).
8 Echo
0 Echo message
11 Time Exceeded
0 Time to live exceeded in transit
1 Fragment reassembly time exceeded
12 Parameter Problem
0 Pointer indicates the error
13 Timestamp
0 Timestamp request message
14 Timestamp Reply
0 Timestamp reply message
15 Information Request
0 Information request message
16 Information Reply
0 Information reply message
Table 67 Sys log
LOG MESSAGE DESCRIPTION
Mon dd hr:mm:ss hostname
src="<srcIP:srcPort>"
dst="<dstIP:dstPort>"
msg="<msg>" note="<note>" This message is sent by the "RAS" when this syslog is
generated. The messages and notes are defined in this
appendix’s other charts.
Table 66 ICMP Notes (continued)
TYPE CODE DESCRIPTION
Table 68 Log Categories and Available Settings
LOG CATEGORIES AVAILABLE PARAMETERS
error 0, 1, 2, 3
mten 0, 1
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to record only
alerts for that category, and 3 to record both logs and alerts for that category.