Activeforever Invacare SOLO2 Portable Oxygen Concentrator - Manual (Page 10)

SECTION 1—GENERAL GUIDELINES
Invacare SOLO
2
™ 10 Part No 1156872
Maintenance
The transportable oxygen concentrator was specifically
designed to minimize routine preventive maintenance. Only
professionals of the healthcare field or persons fully
conversant with this process such as factory trained
personnel should perform preventive maintenance or
performance adjustments on the oxygen concentrator.
Radio Frequency Interference
This equipment has been tested and found to comply with
EMC limits specified by IEC/EN 60601‐1‐2. These limits are
designed to provide a reasonable protection against
electromagnetic interference in a typical medical installation.
Other devices may experience interference from even the low
levels of electromagnetic emissions permitted by the above
standards. To determine if the emissions from the
transportable oxygen concentrator are causing the
interference, turn the transportable oxygen concentrator Off.
If the interference with the other device(s) stops, then the
transportable oxygen concentrator is causing the
interference. In such rare cases, interference may be reduced
or corrected by one of the following measures:
• Reposition, relocate, or increase the separation
between the equipment.
• Connect the equipment into an outlet on a circuit
different from that to which the other device(s) is
connected.
Polarized Plug Instruction
As a safety feature, this appliance may have a polarized plug
(one blade is wider than the other). This plug will fit in a
polarized outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. DO NOT attempt to defeat this safety
feature.