Activeforever Invacare SOLO2 Portable Oxygen Concentrator - Manual (Page 19)

SECTION 6—OPERATING INSTRUCTIONS
Part No 1156872 19 Invacare SOLO
2
™
Powering the Transportable Oxygen
Concentrator
ƽ WARNING
Use only Invacare specified power supplies with the
transportable oxygen concentrator. Use of other non approved
power supplies with the transportable oxygen concentrator
can cause damage and/or injury and will void the warranty.
When using the DC Power Cable to either operate or charge
the transportable oxygen concentrator, the car/boat/motor
home engine should be operating.
NOTE: The battery module requires full charging prior to first use. Refer to
Charging the Battery on page 21.
NOTE: For this procedure, refer to FIGURE 6.1 on page 20.
1. The transportable oxygen concentrator allows the freedom to choose
from the following power sources:
• The replaceable battery module. The transportable oxygen
concentrator comes equipped with a rechargeable lithium battery
module that is not user serviceable. When fully charged, it supplies
power for up to 4.5 hours, depending on the setting.
• An AC power adapter allows the transportable oxygen
concentrator to be connected to a 100‐240 volt 50/60 hertz outlet (i.e.
wall outlet of your home). The power adapter converts AC voltage
to a DC voltage that can be used to power the transportable oxygen
concentrator. Use of the AC power adapter will allow the
transportable oxygen concentrator to operate and simultaneously
recharge the battery module. To use, connect the AC power adapter
to the transportable oxygen concentrator as shown in (DETAIL
“C”). Connect the other end to the AC power outlet.
• A DC power cable allows the transportable oxygen concentrator to
be connected to an automobile’s (boat, motor home, etc.…) 12‐volt
DC outlet. Use of the DC power cable will allow the transportable
oxygen concentrator to be operated and simultaneously recharge
the battery module (depending on the flow setting). To use, connect
the DC power cable to the transportable oxygen concentrator as
shown in (DETAIL “C”). Connect the other end to the DC power
source.
NOTE: Continuous flow is limited to 2.0 LPM or less with the DC power cable.