Ohaus CD-33 Indicator - Manual (Page 10)

10
CD Indicators
• Plug the AC adapter to an appropriate power supply. Power is now applied to the Indicator.
• The Indicator performs a self-test. This test is finished when the display indicates WEIGH.
.
2.5 Connecting Power
Connect the AC Adapter supplied to the connector located at the bottom of the Indicator. Route the wire from the AC
Adapter through the channel in the bottom of the Indicator. This will relieve stress on the connector and hold the wire
in place.
2.5.1 Cautionary Notes
• Models CD-31 and CD-33 Indicators must not be operated in hazardous areas.
• Before connecting the AC adapter, verify that the voltage printed on it corresponds to the local mains
voltage. If this is not the case, please contact your local Ohaus dealer.
• Model CD-31 and CD-33 Indicators may only be used in a dry environment.
2.5.2 Turning On the Indicator
NOTICE:
The socket/outlet must be installed near
the equipment and shall be easily accessible.
Stabilization
Before initially using the Indicator, allow time for it to adjust to its new environment. When the CD-31/CD-33 is first
plugged in, the recommended warm up period is five (5) minutes. The internal circuits of the Indicator are powered
whenever it is plugged into a power source
2.5.3 Power ON/OFF
The CD-31 and CD-33 Indicators consume minimum power. The Indicator does not have an ON/OFF button for power.
It is recommended not to remove power from the Indicator to ensure longer life of the circuitry and display. If you
desire to use the sleep mode, refer to paragraph 3.2 under Readout for settings. NOTE: Sleep mode when set on
removes power only from the display after 5 minutes. Power remains applied to the Indicator at all times when con-
nected to a power source.