Ohaus CD-33 Indicator - Manual (Page 39)

39
CD Indicators
Procedure
• Press the Mode button, WEIGH is displayed.
• Press or button until CHECK W is dis-
played.
• Press Enter button to continue, MIN 0000000 is dis-
played with the first digit blinking.
• Using the numerical keypad or arrow buttons, enter
the minimum acceptable weight for the item being
checked. Sample illustrates 1.90kg.
• Press Enter button to continue, the display indicates
MAX 0000000 with the first digit blinking.
NOTE: Weights are not accepted unless entered as a
multiple of display increment.
• Using the numerical keypad or arrow buttons, enter
the maximum acceptable weight for the item being
checked. Sample illustrates 2.10kg
• Press Enter button to continue, UNDER is displayed
with no object on the pan. Place the item to be
checked on the pan. If the item is within the tolerance
you set, the display indicates OK with the weight of
the item. If the item is over weight, the display
indicates OVER with the weight displayed.
• To check similiar items, simply remove the first item
and place another item on the pan to check. It is not
neccessary to press any buttons to check addi-
tional items. Container can be tared anytime during
operation: container on scale, press Tare button.
When Tare was entered, display always shows NET
weight (G/N/T button disabled).
• To return to weighing mode, press MODE button,
CHECK W is displayed.
• Press button until WEIGH is displayed, then
press Enter button. Indicator in now in a weighing
mode.
4.6 Checkweigh
Checkweigh is enabled only when Checkweigh is turned ON in the Mode submenu under setup. Checkweigh permits
entering a minimum weight value and a maximum weight value though the numerical keypad or arrow buttons. You can
establish minimum and maximum values for repeitive weighing of identical objects. This is suited for production where
a large number of items have to be checked against preset parameters.
(Tare was entered)