Ohaus CW-11 Indicator - Manual (Page 11)

8
CW-11 Indicator
2.6.3 Operating the Indicator
Once the Indicator and Scale Base are connected and installed, follow the setup procedure outlined below.
2.7 Setup Protection
The CW-11 Indicator is equipped with menus which permit certain functions to be locked out (not changed)
during operation. If you intend to lock out changes to the setup selections you make, do not re-assemble the
indicator. You will need to access the cal jumper located on the main PC circuit board following the setup
procedure.
Power On/Off
With the Indicator connected to an appropriate power supply, press the ON/ZERO/OFF button. The Indicator
performs a self-test, indicates the software revision momentarily and then goes to a weighing mode. At this
point, the Indicator is on and ready for initial setup.
Stabilization
Before initially using the Indicator, allow time for it to adjust to its new environment. Recommended warm up
period is five (5) minutes.
2.8 Initial Setup
For first time setup, step through all menus and set the parameters as desired. As the last step, enter the CAL
menu and calibrate the system.
The indicator has five menus; CAL, SETUP, READ, PRINT and LOCSW which are entered by pressing and holding
the G/N/T/MENU button until MENU is displayed, then releasing it. The display then switches to CAL. To access
the rest of the menus, the PRINT/UNITS button is repeatedly pressed until the desired menu is reached.
2.8.1 Control Functions
During setup, only the PRINT/UNITS and G/N/T/MENU buttons are used.
PRINT/UNITS Button
Change between menus horizontally or change sub-menu parameters.
G/N/T/MENU Button
Press and hold to enter menu. Enters menu and steps through sub-menus vertically.