Ohaus CW-11 Indicator - Manual (Page 23)

20
CW-11 Indicator
INTERVAL - PRINTING (Cont.)
Pressing the TARE button increments the digit from 1
to 0. When the desired number of seconds have
been entered, press the G/N/T/MENU button. Stb
OFF is displayed.
STABLE
When set ON, allows only stable weight values to be
printed. When set OFF, prints immediate value with an
indication of stability. In LFT, fixed to ON.
With Stb OFF displayed, press PRINT/UNITS button,
and select ON or OFF. Default setting is OFF.
SAVE
Press G/N/T/MENU button to end this block, SAVE is
displayed. All settings are retained.
Press G/N/T/MENU button to save settings, LOCSW
is displayed which isthe next menu or press PRINT/
UNITS button to go back to Read menu without
saving.
NOTE:(If initial setup, go to the next paragraph. To
exit from the Setup, press PRINT/UNITS button to
skip to LOCKSW, then QUIT. Press G/N/T/MENU
button to go back to the weighing mode).
2.8 Initial Scale Setup (Cont.)
2.8.6 Print Menu (Cont.)
2.8 Initial Scale Setup (Cont.)
2.8.7 Lockout Switch Menu
Lockout Switch menu (LOCSW) is a software controlled option which can lock the settings in the Calibration,
Setup, Readout, and Print menus to prevent tampering. When used in conjunction with the Lock Switch
(jumper) on the printed circuit board, the Calibration, Setup, Readout and Print menus can be read only and
not changed by an operator or the jumper can be left in place and the LOCSW menu is used to prevent acci-
dental changes..
Procedure
To select any of the items in the Lockswitch menu,
proceed as follows: NOTE: If you have entered from
the preceeding menu, disregard the first step.