Ohaus CW-11 Indicator - Manual (Page 21)

18
CW-11 Indicator
2.8 Initial Scale Setup (Cont.)
2.8.6 Print Menu
The Print menu provides data communication settings which can be entered. It contains 9 submenus: Reset,
Baud rate, Parity Bit, Data Length, Stop Bits, Auto Print, Interval, Stable and Save.
Procedure
PRINT
To select any of the items in the Print menu, proceed
as follows: NOTE: If you have entered from the
preceeding menu, disregard the first step.
With the Indicator ON, press and hold the G/N/T/
MENU button until MENU is displayed. When you
release the G/N/T/MENU button, CAL is displayed,
then press PRINT/UNITS button, until Print is dis-
played.
RESET
Press G/N/T/MENU button, rESEtn is displayed. This
allows resetting the Print menu to factory defaults.
rESETn = no does not reset settings. rESETy= yes
will reset the entire Print menu as follows:
Baud rate =2400, parity =none, data length=7,
stop bit=2.
Press PRINT/UNITS button, and select N or Y.
BAUD RATE
Press G/N/T/MENU button, bd2400 displayed.
Press PRINT/UNITS button, and select desired baud
rate. Baud rate selections are: 1200, 2400, 4800
9600 and 19200. 2400 is the default setting.
PARITY
Press G/N/T/MENU button, PAr NO is displayed.
This is the parity bit.
Press PRINT/UNITS button, and select desired parity
of NO=none, Odd=odd, E=even. Default setting is
none.