5 setup – VEGA VEGAMET 614V User Manual
Page 18
Advertising
18
VEGAMET 614V
Setup
5 Setup
• Set the VEGAMET instrument address on
the circuit board by means of the rotary
switch (only necessary, if several
VEGAMET are connected on the DISBUS).
• Install VEGAMET.
• Connect sensor and power supply.
• After switching on, the display indicates for
approx. 10 secs the instrument type and
the software version, e.g. „MET 614V
V1.12“.
• If a measurement loop has not yet been
configured, the display shows „Configura-
tion“, the red failure LED also lights. In this
case, proceed as described under „6.1
Configuration of measurement loop“.
• If a measurement loop has been
configured, the display shows a value, e.g.
„TAG-No. 1 21.8 %“.You can now carry out
the settings as described in the chapter „6
Settings in the reduced menu“.
Advertising