Toshiba Pocket PC e800 - Manual (Page 11)

User’s Manual xi
Therefore Toshiba strongly recommends that the electromagnetic
compatibility of this product be suitably tested in all non-approved working
environments before use. In the case of automobiles or aircraft, the
manufacturer or airline respectively should be asked for permission before
use of this product.
Furthermore, for general safety reasons, the use of this product in
environments with explosive atmospheres is not permitted.
CE compliance
This product and the original options are designed to observe the related
EMC (Electromagnetic compatibility) and safety standards. However,
Toshiba cannot guarantee that this product still observes these EMC
standards if options or cables not produced by Toshiba are connected or
implemented. In this case the persons who have connected/implemented
those options/cables have to make sure that the system (PC plus options/
cables) still fulfils the required standards. To avoid general EMC problems,
the following advice should be observed:
■ Only CE marked options should be connected/implemented
■ Only best shielded cables should be connected
FCC Notice “Declaration of Conformity”
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
■ Consult the dealer or an experienced radio/TV technician for help.
Only peripherals complying with the FCC class B limits may be attached to
this equipment. Operation with non-compliant peripherals or peripherals
not recommended by Toshiba is likely to result in interference to radio and
TV reception. Shielded cables must be used between the external devices
and the computer’s USB ports, external monitor port, PS/2 keyboard port
and PS/2 mouse port.Changes or modifications made to this equipment,
not expressly approved by Toshiba or parties authorized by Toshiba could
void the user’s authority to operate the equipment.