R&M Materials Handling VARIABLE SPEED CONTROLS ControlMaster NXT Service Manual User Manual
Page 14
R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
14/53
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
Screw mounting with integrated braking resistor
1
Initially tighten the screws so that they can be fitted in the holes in
the upper part of the braking resistor housing.
Use screw size: M5 with screw locking liquid.
2
Once the device is held up by the screws, tighten the upper screws
and then fit screws in the lower part of the braking resistor housing.
DIN rail mounting
1
Incline the device and insert the upper edge of the rail into the rail
groove on the device.
2
Press the lower part until it locks into the rail.