SENA Parani10 - Manual (Page 13)

13
3. Configuration
3.1 Using Parani10 Manager
With Parani10, Bluetooth wireless connections can be made to any Bluetooth device
supporting SPP (Serial Port Profile). Especially when using the Parani10 as a cable
replacement, take advantage of the Parani10 automatic connection feature. Once a pair of
Parani10’s is set for this feature, they automatically connect whenever powered up. A pair of
Parani10 units, within their radio range, may be used as a virtual RS-232 cable.
To allow wireless connections between two Bluetooth devices, one device should be in
Discoverable (INQUIRY SCAN) and Connectable (PAGE SCAN). Most Bluetooth devices are
set to Discoverable and Connectable by the manufacture. However, to allow Parani10 to
respond to the INQUIRY and PAGE operations of other Bluetooth devices, INQUIRY SCAN and
PAGE SCAN modes will need to be activated.
Before making the first Bluetooth connection with Parani10 units, be prepared with a pair of
Parani10 units and also install the Parani10_Manager program on the CD enclosed in the
Parani10 product package.
*Configuration By Parani10_Manager
Please prepare two of the Parani10s to make connection.
Let’s say 1
st
unit as ‘ P01 ’and 2
nd
unit as ‘ P02 ’in this guide book. Make sure that power to both
P01 and P02 are ALWAYS supplied, even when you detach from your computer.
3.1.1 Let’s make P01 to be discoverable/connectable.
In this procedure, P01 will become discoverable/connectable to be able to receive connection
from P02 .
1-1. Attach P01 to your PC, and start Parani10_Manager
1-2. Start Parani10_Manager then you will see a pop-up window for configuration of
Parani10_Manager.