SENA Parani10 - Manual (Page 38)

38
recently connected Bluetooth device.
AT+BTMODE, n<cr>
Function : Set the operating mode of your PARANI10.
Response : <cr><lf>OK<cr><lf>
Description : Your PARANI10 has 4 different operating mode. According to the current
operating mode you set, your PARANI10 behavior differently.
n=0 : This means your PARANI10 is in MODE 0. MODE 0 is the default
configuration.
n=1 : In MODE 1, your PARANI10 will try to make connection to most recently
connected Bluetooth device.
n=2 : In MODE 2, your PARANI10 will wait connection from most recently
connected Bluetooth device.
n=3 : IN MODE 3, your PARANI10 does INQUIRY SCAN and PAGE SCAN
alternately.
AT+BTNAME=”FriendlyName”<cr>
Function : Assign user friendly device name to your PARANI10.
Response : <cr><lf>OK<cr><lf>
Description : You can assign your PARANI10 user friendly name by using this AT command.
With the assigned name, you can distinguish your PARANI10 easily from
other Bluetooth devices. Up to 32 characters are permitted as user friendly
name.
AT+BTKEY=”nnnn”<cr>
Function : Change the passkey.
Response : <cr><lf>OK<cr><lf>
Description : When the authentication is enabled in your PARANI10, you should assign
passkey. Two Bluetooth devices which are to be connected should have the
same passkey. The default passkey of your PARANI10 is ‘1234’. You can
assign maximum 16 alphanumeric characters as a passkey.
AT+BTINFO?<cr>
Function : Return the internal status of your PARANI10.
Response : <cr><lf>BD_ADDR,Name,Mode,Status,Auth,Encryp<cr><lf>
<cr><lf>OK<cr><lf>