6 at command vs. operational status – SENA Parani10 User Manual
Page 25
Advertising
25
their counterpart in their internal Flash.
When desired, release the
connection as directed in section 3.2.4.
4. Set the operating mode of one Parani10 to MODE 1 by entering an ‘AT+
BTMODE’command as shown below.
5. Set the operating mode of the other Parani10 to MODE 2 by entering an
‘AT+BTMODE’command as show below.
6. Turn both Parani10 units power off.
The Parani10 pair will connect
automatically when they are powered up again.
7. To release this paring, set them to MODE 0 by entering ‘AT+BTMODE, 0’. or
reset the units by pressing the RESET button.
3.2.6 AT command vs. Operational Status
The AT command sets listed above can be executed per Parani10 operational status.
The
AT+BTMODE,0
OK
AT+BTCANCEL
OK
AT+BTMODE,2
OK
AT+BTMODE,1
OK
Advertising