SENA Parani10 - Manual (Page 49)

49
1) By Parani10_Manager, check OFF at Signal pane at Device Setting panel to disable 4
response signals from Parani10.
2) By AT commands at your Terminal program.
ATS10=1 : Enabling/ON 4 signals
ATS10=0 : Disabling/OFF 4 signals
ATS10? : To see current status
C.3 For DCE connection
Parani10 is twisted Rx/Tx-ready for direct DTE connection. For connection to DCE equipment
such as modem etc., customers need to use a gender changer that twisted Tx/Rx, CTS/RTS,
and DTR/DSR for correct operation.
For more information, please contact [email protected]