SENA Parani10 - Manual (Page 23)

23
2. Enter the ‘AT+BTSCAN’command. The Parani10 will start INQURY SCAN
and PAGE SCAN operation. During the process, the Parani10 will flash
twice every 3 seconds until it is connected to another Bluetooth device.
3. Try Bluetooth connection to the Parani10 from the other Bluetooth device.
Once connected the first Parani10 will return the ‘CONNECT’message and
the STATUS LED will display a continuous green without flashing.
3.2.4 Releasing the existing Bluetooth connection
Once connected successfully, the Parani10 becomes transparent to any serial
applications on hosts. Data may be transferred within the radio range of the
Parani10. According to Parani10 terminology, this operating status is called
‘ONLINE STATUS’. In ONLINE STATUS, all AT commands are treated as
characters and are ignored by the command interpreter of the Parani10.
Therefore to escape from ONLINE STATUS enters escape string ‘+++’.
AT+BTSCAN
OK
CONNECT
AT+BTSCAN
OK
AT+BTINFO?
000B530000A9,PARANI10-0000A9,MODE0,STANDBY,0,0
OK