SENA Parani10 - Manual (Page 42)

42
15)
AT+BTLAST?<cr> <cr><lf>OK<cr><lf> Query the bd-address of last
connected device
16)
AT+BTMODE,n<cr> <cr><lf>OK<cr><lf> Sets the mode of device.
If n=0, device operates in Standard
mode which accepts all AT
commands.
If n=1, device operates at Master
mode which try to connect peer
device.
If n=2, device operates at Slave
mode which waiting for connection.
If n=3, device operates at always
connectable mode.
17) AT+BTNAME=”FriendlyName”<cr> <cr><lf>OK<cr><lf> Sets the friendly name of this unit.
18)
AT+BTKEY=”nnnn”<cr> <cr><lf>OK<cr><lf> Sets the Passkey of this unit.
Up to 16 characters.
19)
AT+BTINFO?<cr> <cr><lf>112233445
566,FriendlyName,
Mode,State,Authent
ication,Encryption<
cr><lf>
<cr><lf>OK<cr><lf>
Retrieve local device information
including BD address, Friendly name,
mode of device, internal operation
state and status of authentication and
encryption features.
20)
AT+BTLPM,n<cr> <cr><lf>OK<cr><lf> Enable or disable the low power
mode of dongle.
n = 1 or 0
21)
AT&V<cr> <cr><lf>S0: m0;S1:
m1; … Sn:
mn<cr><lf>
<cr><lf>OK<cr><lf>
View all the values of internal S-
registers
22)
AT+BTSD?<cr> <cr><lf>bdaddr of
secured device
1<cr><lf>
<cr><lf>bdaddr of
secured device
1<cr><lf>
<cr><lf>OK<cr><lf>
Query the bd-addresses of secured
devices