SENA ProBee-ZE20S-HAOL User Manual
Page 41
ProBee-ZE20S-HAxx User Guide Rev 1.9
41
Figure 5-3 Example #2: 1 Coordinator and 2 End-Devices
5.4.1
ProBeeHACI Coordinator Configuration
Hardware configuration for the coordinator is as follows:
Set the HOST switch to UART
Connect a serial cable between a host computer and the coordinator
Update ProBeeHACI firmware (See Chapter 2.3.3)
The AT commands for coordinator configuration is as follows:
AT+NODETYPE=1
OK
AT+PANID=7772
OK
ATZ
OK
5.4.2
ProBeeHADL End-device Configuration
Hardware configuration for the coordinator is as follows:
Set the GPIO_OUT switch to LED_ON
Update ProBeeHADL firmware (See Chapter 2.3.3)
The AT commands for the ProBeeHADL end-device are as follows:
AT+NODETYPE=3
OK
AT+PANID=7772
OK
AT+GPIO=66666666666666666
OK