SENA ProBee-ZE20S-HAOL - Manual (Page 74)

ProBee-ZE20S-HAxx User Guide Rev 1.9 74
node according to GPIO monitoring node (S43). If set to 0, GPIO change detection
sampling is disabled.
Execute ATS44?<CR> ATS44=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 0
Range 0 – 1
8.3.5 S45
Description
Get/Set the GPIO remote control mode. If any GPIO pin is set to digital input, a node
can control the I/O status of a remote node if the I/O pin of the remote node is set to
digital output. It is possible to use when GPIO monitoring is enabled (GPIO monitoring
period, S42 > 0) or GPIO change detection sampling is enabled.(GPIO change
detection sampling mode, S44 = 1)
Execute ATS45?<CR> ATS45=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 0
Range 0 – 1
8.4 End-Device
8.4.1 S51
Description
Get/Set the poll timeout for a parent node in seconds. If an end-device or a sleepy
end-device does not send a poll request to its parent coordinator or router within the
poll timeout, the end-device is removed from the child table.
Execute ATS51?<CR> ATS51=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 60
Range 0 – 4177920
8.4.2 S52
Description
Get/Set the sleepy end-device poll period in milliseconds. Adaptive polling may allow
the sleepy end-device to poll more rapidly for a short time when receiving RF data.
Execute ATS52?<CR> ATS52=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 100
Range 0 - 10000