SENA ProBee-ZE20S-HAOL - Manual (Page 62)

ProBee-ZE20S-HAxx User Guide Rev 1.9 62
the parent are also displayed.
Execute AT+RSSI?<CR>
Response
Sender: <node ID>, Parent: FFFF, RSSI: <RSSI value>, LQI: <LQI value><CR>
OK<CR>
7.5.5 AT+NODETYPE or AT+NT
Description
Get/Set the node type. (0: none, 1: coordinator, 2: router, 3: end-device, 4: sleepy
end-device)
Execute AT+NODETYPE?<CR> AT+NODETYPE=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 0
Range 0 – 4
7.5.6 AT+PERMIT or AT+PJ
Description
Permit other nodes to join the network. (0~254s, 255=continuance) An end-
device cannot perform it.
Execute AT+PERMIT<CR> AT+PERMIT=<value><CR>
Response OK<CR>
Range 0 – 255
7.5.7 AT+LEAVE or AT+LV
Description Leave the current network.
Execute AT+LEAVE<CR>
Response OK<CR>
7.6 End-device
7.6.1 AT+SLEEP or AT+SM
Description Enter the sleep mode immediately if the node is a sleepy end-device.
Execute AT+SLEEP<CR>
Response OK<CR>
7.6.2 AT+PARENTLA or AT+PL
Description Get the 64-bit IEEE address of the parent node.
Execute AT+PARENTLA?<CR>
Response
<IEEE address><CR>
OK<CR>