SENA ProBee-ZE20S-HAOL - Manual (Page 60)

ProBee-ZE20S-HAxx User Guide Rev 1.9 60
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 0000
Range 0000 – FFFF
7.4.5 AT+POWER or AT+PW
Description Get/Set the TX power at which the RF module transmits conducted power.
Execute AT+POWER?<CR> AT+POWER=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 8
Range -43 – 8
7.4.6 AT+STACK or AT+ZS
Description
Get/Set the ZigBee stack profile value. This value must be set the same on all
devices that should join the same network. (0: Network specific, 1: ZigBee, 2:
ZigBee Pro)
Execute AT+STACK?<CR> AT+STACK=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 2
Range 0 – 2
* Default value changed 2 from 0
7.4.7 AT+NODENAME or AT+NN
Description
Get/Set the node name. It can be used to make a clear distinction role or
functionality of local node from others.
Execute AT+NODENAME?<CR> AT+NODENAME=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default ProBee-HAxx
Range Up to 16 characters
7.5 Network Formation and Join
7.5.1 AT+ASCAN or AT+AS
Description
Perform a scanning for existing network. It can take up to 5 seconds. (CAUTION:
It is possible to cause a link error if a node is a parent of an end-device.)
Execute AT+ASCAN<CR> AT+ASCAN=<channel mask><CR>
Response <channel>|<PAN ID>|<EPID>|<joinable>|<stack profile>