SENA ProBee-ZE20S-HAOL User Manual
Page 42
ProBee-ZE20S-HAxx User Guide Rev 1.9
42
AT+LONGADDR
0001950000000005
OK
ATZ
OK
5.4.3
ProBeeHAOL End-device Configuration
Hardware configuration for the coordinator is as follows:
Set the GPIO_OUT switch to LED_ON
Update ProBeeHAOL firmware (See Chapter 2.3.3)
The AT commands for the ProBeeHAOL end-device are as follows:
(Same as ProBeeHADL end-device)
AT+NODETYPE=3
OK
AT+PANID=7772
OK
AT+GPIO=66666666666666666
OK
AT+LONGADDR
0001950000000003
OK
ATZ
OK
5.4.4
Turning on/off the ProBeeHADL End Device LEDs from ProBeeHACI Coordinator
The AT commands to turn on the LEDs of the ProBeeHADL End Device are as follows:
AT+ADDRDISCOVERY=0001950000000005
B862
OK
AT+DEST=B862,01
OK
AT+CWRITE=0101,0000,01
OK
* Short address ‘B862’ can be shown differently in your device.