SENA ProBee-ZE20S-HAOL - Manual (Page 80)

ProBee-ZE20S-HAxx User Guide Rev 1.9 80
0000|0000|01 (Basic)
0000|0001|00 (Basic)
0000|0002|00 (Basic)
0000|0003|00 (Basic)
...
0002|0010|00 (Device Temperature Configuration)
0002|0011|0000 (Device Temperature Configuration)
0002|0012|0000 (Device Temperature Configuration)
0002|0013|000000 (Device Temperature Configuration)
0002|0014|000000 (Device Temperature Configuration)
0003|0000|0000 (Identify)
OK # Response
# clus: cluster id
# attr: attribute id
# data: stored data
9.4 Reading Attribute
User can read attribute of local node or remote node by running the AT command as below:
 AT+SREAD can be used for reading attribute of local node.
 AT+CREAD can be used for reading attribute of remote node.
 User should set destination address by command AT+DEST before running AT+CREAD.
 Destination node must implement corresponding attribute and cluster.
Example) Read attribute of local node.
AT+SREAD=0000,0007<CR> # Read device attribute
# Basic cluster(0x0000),
# Power source attribute(0x0007)
2 # Unlocked
OK # Response
Example) Read attribute of remote node.
AT+DEST=0000,01<CR> # Set destination node address
OK # Response
AT+CREAD=0101,0000<CR> # Read destination’s attribute
# Door Lock cluster(0x0101),
# Lock state attribute(0x0000)