GE Industrial Solutions EntelliGuard TU Trip Units - Manual (Page 50)

EntelliGuard TU Trip Units: UL/ANSI Models DEH-4567B
Status Screens
40 ©2012 General Electric All Rights Reserved
RELT STATUS INDICATIONS
What this shows:
The source of the RELT command is shown, either via
Modbus command, or external contact closure.
This screen only shows if the RELT option was provided on
the trip
RELT ACTIVATED INDICATIONS
This is the display when RELT is engaged.
What this shows:
The currently displayed window will flash through the four
screen sequence shown above every 2-3 seconds as soon
as RELT is engaged.
After RELT is disengaged, the trip unit will remain in this
mode for approximately 15 seconds.
This sequence will be visible on any window that is
displayed while RELT is engaged.
Any digital output assigned to RELT will remain energized
for the same duration as the status display.
SOFTWARE REVISION
This is the GTU Firmware Revision
display.
What this shows:
This shows the current installed
version of GTU software on the trip
unit.