GE Industrial Solutions AF-600 FP Drive Panel - Manual (Page 39)

39
6. Troubleshooting
In the event that it is desired to “auto-tune” the drive to the connected motor, reference the following
instructions along with the AF-600 FP User’s Guide (DET – 609 or DET - 610):
With power applied to the panel –
1) Place the Hand/Off/Auto selector switches in the “Off” positions respectively. (Need to make sure the
drive is energized but not in a run state)
2) For Full Auto tuning follow the instruction below
Quick Menu
Ok
Quick start
Ok
Once up arrow
Ok
P-04 Auto Tuning
Ok
[1] Full Auto tune
Ok
Follow the Keypad direction
Note: If the panel has a load reactor, select “Reduced Auto tune”.
DEH40608
– Page 13 AN 11-2021 Rev 05, 12/15/2011