GE Industrial Solutions AF-600 FP Drive Panel - Manual (Page 51)

51
Table – 3 (575V)
Device AF - 600 HP Rating(s) Minimum Wire Size Maximum Wire Size Required Torque
NON FUSED
DISCONNECTOR AND
FUSE BLOCK
1 through 10Hp # 14 AWG # 4 AWG Note 1
15 through 40Hp # 14 AWG # 4 AWG Note 1
50 through 60Hp # 8 AWG 1/0 Note 1
75 through 100Hp # 8 AWG 1/0 Note 1
125 through 150Hp # 4 AWG 300 MCM Note 1
200 through 300Hp # 2 AWG 600 MCM Note 1
FUSED DISCONNECTOR 1 through 40 # 10 AWG # 3 AWG Note 1
50 through 60 # 14 AWG # 2/0 AWG Note 1
75 through 125 # 6 AWG # 3/0 AWG Note 1
150 through 300 # 2 AWG 600MCM Note 1
350 through 650 2 X # 2 AWG 2 X 600MCM Note 1
Circuit Breaker 1 through 75 # 12 AWG # 3/0 AWG Note 1
100 through 200 # 8 AWG 350 MCM Note 1
250 through 450 2 X 2/0 2 X 500 MCM Note 1
250 through 450 #8 AWG 600 MCM Note 1
500 through 650 3X #3/0 AWG 3X 500 MCM Note 1
Overload Relay 2 through 25 # 14 AWG # 8 AWG 20 lb. in.
30 through 75 # 10 AWG # 3 AWG 50 lb. in.
100 through 150 # 6 AWG 250 MCM 275 lb. in. Note 2
Drive output power
Terminal Board
1 through 10
# 4 AWG
# 10 AWG
16 lb.in
15 through 25 # 16 AWG # 6 AWG 16 lb.in
30 through 50 # 35 AWG #2 AWG 40 lb.in
60 through 75 # 50 AWG 1/0 89 lb.in
100 # 95 AWG 4/0 212 lb.in
125 150MCM 250MCM 212 lb.in
150 through 200 2x2/0 2x2/0 Note 1, 2
250 through 400 2x350MCM 2x350MCM Note 1, 2
450 through 650 4x500MCM 4x500MCM Note 1, 2
Continued…
DEH40603 – Page 5 AN 12-1007 Rev 05, 04/04/2012