GE Industrial Solutions Control System Toolbox For AV-300, DV-300, AV-300i (AVDV Series) Drives - Manual (Page 57)

GEH-6405A Toolbox for an AVDV Series Drive Chapter 4 Configuring an AVDV Series Drive
•
4-27
Printing Diagrams
Tip ¬
The block diagram(s) is designed to print in Landscape Orientation. From
the File menu, choose Print Setup and click the option Landscape .
À
To print block diagrams
Or click
1. From the Outline View , click the item Diagram .
2. From the File menu, choose Print . The Print dialog box displays.
3. Choose the number of copies to print and the page(s).
This field shows that there are 17
diagrams in this device.
Click OK to print all the diagrams
or enter the page number(s) to
print.
Tip
¬
To print a single block diagram, link to that page, so that it displays on the
screen and click . Choose OK . Live data can be printed, if the drive is online.
Drive Controls
The Drive Controls command enables you to operate the drive from the toolbox, as
though you were operating it directly from the keypad located on the cabinet door.
The variables that display are the same as those that display on the keypad.
Note The actual Drive Controls (keypad) can vary depending on the product that
connected to the toolbox.
Or click .
À To display the Drive Control view
w From the
View menu, choose Drive Control . The Drive Control view
displays.
Click here to toggle the
direction of the drive
(reverse resquest). The
selected direction is shown
with an icon or
Click here to reset faults.
Click here to Run the
drive in the selected
direction.*
Stop command can be
used in Local or Remote
mode.
Click here to Jog the drive
in the selected direction.*