GE Industrial Solutions Control System Toolbox For AV-300, DV-300, AV-300i (AVDV Series) Drives - Manual (Page 73)

GEH-6405 Toolbox for an AVDV Series Drive Glossary of Terms
•
G3
font
One complete collection of letters, punctuation marks, numbers, and special
characters with a consistent and identifiable typeface, weight, posture, and size.
hexadecimal (hex)
Base 16 numbering system using the digits 0-9 and letters A-F to represent the
decimal numbers 0-15. Two hex digits represent 1 byte.
initialize
To set values (addresses, counters, registers, and such) to a beginning value prior to
the rest of processing.
insert
Adding an item either below or next to another item in a configuration, as it is
viewed in the hierarchy of the Outline View of the toolbox.
logical
A statement of a true sense, such as a Boolean.
model
Interactive setup data (recipe) that automatically adjusts to the process. This function
is usually used with hot mills or cold mills.
module
A collection of tasks that have a defined scheduling period.
non-volatile
The memory specially designed to store information even when the power is off.
online
Online mode provides full CPU communications, allowing data to be both read and
written. It is the state of the toolbox when it is communicating with the system for
which it holds the configuration. Also, a download mode where the device is not
stopped and then restarted.
parameter
A value used to define drive behavior.
physical
Refers to devices at the electronic or machine level in contrast with logical. Logical
implies a higher view than the physical. Users relate to data logically by data element
name; however, the actual fields of data are physically located in sectors on a disk.
put into database
Command in the device menu used to add configuration information into a system
database.