GE Industrial Solutions Control System Toolbox For AV-300, DV-300, AV-300i (AVDV Series) Drives - Manual (Page 72)

G2
•
Glossary of Terms GEH-6405 Toolbox for an AVDV Series Drive
COM port
Serial communication ports (two). COM1 is reserved for diagnostic information and
the Serial Loader. COM2 is used for I/O communication
configure
To select specific options, either by setting the location of hardware jumpers or
loading software parameters into memory.
dead band
A range of values in which the incoming signal can be altered without changing the
outgoing response.
device
A configurable component of a process control system.
Diagram
Click on this item in the Outline View for an overall picture (in the Summary View)
of drive function.
diagram links
Click on a button to go to other pages of diagrams or information on drive functions.
Drive Control
Enables you to control the drive from the toolbox, the same as the keypad on the
cabinet door.
EIA
Electronics Industry Association (EIA), a trade organization representing the U.S.A.
high technology community. The EIA establishes Recommended Standards (RS) for
hardware devices and their interfaces.
EEPROM (EE)
Electronically erasable programmable read-only memory.
fault
A message from the drive indicating a warning or failure.
Finder
A subsystem of the toolbox for searching and determining the usage of a particular
item in a configuration.
firmware
The set of executable software that is stored in memory chips that hold their content
without electrical power, such as EEPROM.
flash
A non-volatile programmable memory device.