Hardware settings, Jumper settings – GE Industrial Solutions Control System Toolbox For AV-300, DV-300, AV-300i (AVDV Series) Drives User Manual
Page 69
Advertising
GEH-6405A Toolbox for an AVDV Series Drive
Chapter 4 Configuring an AVDV Series Drive
•
4-39
Hardware Settings
Jumper Settings
JP1
On - If using the RS-232C port
Off - If using the RS-485 port
JP6
Always on pins 1 & 2
JP7
Always on pins 1 & 2
JP2
On - If using RS-485 port and
Genius board is last device on
network (default)
Off - If using RS-485 port and
Genius board is in middle of the
network
JP8
JP9
On - To clear Genius board settings on
power up
Off - To retain Genius board settings
on power up
Not used
JP3
JP4
Always on pins 1 & 2
Always on
JP10
On - 5 Vdc Power is supplied to the
RS-485 port
Off - No power is supplied to the RS-
485 port
JP5
Always on pins 1 & 2
Advertising