GE Industrial Solutions AF-600 FP High Power Unit Sizes 6x - Manual (Page 18)

2.2.5 Navigation Keys
Navigation keys are used for programming functions, moving the display cursor, and speed control in local controller operation. Controller status indicator lights
are also located in this area.
Back Reverts to the previous step or list in the navigation structure.
Cancel The last change or command will be cancelled, as long as the display mode has not changed.
Info Press [Info] for information about a command, parameter, or function in any display mode. For example, in status mode, each display is defined. In menu
mode, menu options are explained. Exit Info mode by pressing [Info], [Back], [Cancel], or [Status].
Navigation Arrow Keys The four navigation arrows are used to move a cursor between the different items available in menu or alarm log modes. For operation
in Hand Mode, the up and down arrows regulate controller speed.
OK Used to select a highlighted parameter from a parameter list or to enable a parameter choice.
LED indicator lights The green ON LED is activated and display panel lit when the frequency converter receives power from mains voltage, a DC bus terminal, or
an external 24 V supply.
When a pending fault condition is being approached, the yellow warning light will come on and a text display appears in the display area. A fault condition causes
the alarm LED to flash red and a text display appears in the display area.
Darkened LED lights on the Keypad do not mean that the drive has no dangerous internal voltage. Do not assume the unit contains no voltage
when the indicator lights are off.
2.2.6 Controller Operation Keys
Operation keys for local or auto (remote) control are found at the bottom of the Keypad along with Off and Reset.
[Hand] Starts or operates the motor in local control through the Keypad. Use the up and down arrow keys to give the motor a speed command. The key can be
Enabled [1] or Disabled [0] via par. K-40 [Hand] Button on Keypad.
NB!
External stop signals activated by means of control signals or a serial bus will override a start command via the Keypad.
High Power Service Manual for Unit Sizes 6x
17
2