Extron Electronics MTPX Plus Series User Guide - Manual (Page 119)

Windows Buttons, Drop Boxes, and Trashcan
The buttons, drop boxes, and trash can on the right side of the program window perform
the following functions:
Power — Unavailable for MTPX Plus Twisted Pair switchers, because the
switcher power cannot be controlled via software.
Executive Mode — Allows you to lock out front panel operations, except
for the view-only mode functions. Click the button to cycle between Lock
mode 0 (the indicator is white), Lock mode 1 (the indicator displays red),
and Lock mode 2 (orange).
NOTE: See “ Setting the Front Panel Locks (Executive Modes) ”
in the “Operation” section for definitions of the Lock modes.
Room menu — Displays a list of up to 10 rooms. You can select a room from
the list to display it in the window.
NOTE: A Room is a subset of outputs that are logically related to
each other, as determined by the operator. The MTPX Plus
switcher supports up to 10 rooms, each of which can consist
of from 1 to 16 outputs.
Presets menu — Displays a list of up to 32 global presets and up to 100
room presets. You can select a preset from the list to display it in the
window and either activate it (Go) or delete it (Delete).
Go — Activates the selected preset as the current configuration.
Save as ... — Allows the current set of ties to be saved as a preset. Enter the preset
number when prompted to do so.
Delete — Allows the current preset to be deleted.
Changes – Take — Saves any changes made to the displayed configuration.
Changes – Cancel — Abandons any changes made to the displayed configuration.
Trashcan — Drag and drop from an input or output button to the trash can to unmake all
ties associated with that input or output.
Windows menus
File menu
Save matrix settings as ... — Saves a complete set of up
to 32 global and 100 room presets, plus the last active setting
(preset #0), to a file. Saved settings include audio gain and
volume settings, MTPX configuration and picture settings,
assigned icons, and icon captions.
Restore matrix settings from ... — Loads and activates a
previously saved setting file.
Save this-session’s settings — Saves the current assigned icons and icon captions.
Restore last-session’s settings — Loads the icons and icon captions that were
saved during the last session. If you saved the changes from the previous session to disk
the last time you exited the program, the ties from that session are also loaded.
Select printer — Selects the target printer.
Print tie map — Prints the tie set that is displayed on the screen.
Exit — loses the Matrix Switchers Control Program.
MTPX Plus Series • Matrix Software 113