Extron Electronics MTPX Plus Series User Guide - Manual (Page 67)

Reset the switcher to the factory default settings by pressing and holding the Video button
and Audio button simultaneously while you apply AC power to the switcher (see figure 40).
I / O
VIDEO AUDIO
Press and hold the Video and Audio
buttons simultaneously while you
apply power to the switcher.
Release the Video and Audio buttons.
Power
The switcher flashes
the button indicators
and then turns them off.
Continue to hold the Video and Audio
buttons until all input and output buttons
return to unlit and the Video and Audio
buttons turn on.
Figure 40. System Reset
NOTE: If background illumination was turned on before the reset, the I/O and control
buttons are unlit after the reset. But, when you cycle power, background
illumination returns to as selected.
Background Illumination
The buttons on the front panel can be set to provide amber background illumination at
all times or the background illumination can be turned off. To toggle the background
illumination on or off, press and hold the Input 1 and Input 2 buttons simultaneously for
approximately 2 seconds (see figure 41).
1 2 3 16
17 18 19 32
I
N
P
U
T
S
Press and hold the buttons.
After the illumination status of the
buttons change (after approximately
2 seconds), release the buttons.
Figure 41. Toggle Background Illumination on or off
MTPX Plus Series • Operation 61