Extron Electronics MTPX Plus Series User Guide - Manual (Page 138)

Passwords Page
Access the Passwords page (see figure 80) by clicking the Passwords link on the System
Settings page.
Select Passwords
Refresh
Select Firmware Upgrade
Select Email Settings
Figure 80. Passwords Page
NOTE: If the switcher is password protected, fields on this page can be edited only by
people logged in as administrators.
The fields on the Passwords page are for entering and verifying administrator and
user passwords. Passwords are case sensitive and are limited to up to 12 upper-
case and lower-case alphanumeric characters. Each password must be entered
twice; once in the Password field and then again in the Re-enter Password field.
Characters in these fields are masked by asterisks (
***** ). If you do not want to password
protect an access level, leave the Password field and the Re-Enter Password field blank. After
entering the password in both fields, click the Submit button.
NOTE: An administrator password must be created before a user password can be
created.
Resetting a password
Reset an existing password so that no password is required as follows:
1. Clear any existing password.
2. Enter a single space character in the Password and Re-enter Password fields.
3. Click the Submit button.
MTPX Plus Series • HTML Operation 132