Extron Electronics MTPX Plus Series User Guide - Manual (Page 17)

Installation
This sections details the installation of the MTPX Plus Matrix Switchers, including:
• Mounting the Switcher
• Rear Panel Cabling and Settings
• Front Panel Configuration Port
Mounting the Switcher
CAUTION: Installation and service must be performed by authorized personnel only.
Detailed mounting instructions can be found in the “Reference Information“ section at
the end of this guide. The MTPX Plus switchers are housed in a 1U high (MTPX Plus 128),
2U high (other matrix sizes 1616 and smaller), or 3U high (matrix sizes 1632 and larger)
metal enclosures. The 1U enclosure is rack mountable using the provided MBD 149
Through-desk and rack mounting kit (part number 70-077-03). The 2U and 3U enclosures
are mountable without extra hardware.
Rear Panel Cabling and Settings
Figure 2 shows the rear panel of the MTPX Plus 128.
100-240V 0.8A
50-60Hz
OUTPUTS
1 2
3 4
LOCAL INPUTS INPUTS
1 2 3 4
RESET
LAN
ACT LINK
1
2
L R 2 L R 1
L R 4 L R 3
5 6 7 8
1 2 3 4
5 6 7 8
Tx Rx
L R 2
L R 1 5 6 7 8
9 10 11 12
LOCAL OUTPUTS RS-232 OUTPUT INSERT
REMOTE
RS-232
Tx Rx Tx Rx Tx Rx Tx Rx
10 11 13 9 5 6 8 7 3 2 1
Figure 2. MTPX Plus 128 Twisted Pair Matrix Switcher
Figure 3 shows the rear panel of the MTPX Plus 1616.
RESET
ETHERNET ACT
LINK
MONO AUDIO OUTPUTS
OUTPUTS
RGB
RGB
1
2 3
Tx Rx
1
L R 2
L R 3
L R 4
L R
LOCAL INPUTS
RGB
RGB
LOCAL OUTPUT
INPUT SELECT
ON
LOCAL
RJ - 45
1 2 3
RS-232/RS-422
REMOTE
CONTROL
RS - 232 OUTPUT INSERT
Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx
1.6A MAX
LISTED
1T23
I.T.E.
AUDIO INPUTS
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8
13
10
11
12
7 4 5 8
6 1 2
AUDIO
3
Figure 3. MTPX Plus 1616 Twisted Pair Matrix Switcher
NOTE: The MTPX Plus 816 and MTPX Plus 168 are housed in the same 2U enclosure,
but have fewer input connectors (8 x 16 matrix) or output connectors (16 x 8
matrix) to accommodate their smaller matrix sizes.
MTPX Plus Series • Installation 11